Plague Doctor Mask V2
Added 2020-07-26 07:58:55 +0000 UTCForgot to add this one to the archive, this is a new mask obviously based on the old one but with a few changes, there is new eyes, new eye placements, stitching doesn't fade out at the nose, new lenses and its sized more appropriately to fit a normal head of someone around 170-180cm tall.
Enjoy!
FILES:
Has been added to the Member Depot along side the Plague Mask V1
https://www.hex3dpatreon.com/viewtopic.php?f=295&t=255
Has also been Added to the Starter Pack section for new members
:
https://www.hex3dpatreon.com/viewtopic.php?f=25&t=256
Comments
What would be the easiest way to slice this model in 2? I’ve never sliced anything before but would love to print this mode
Antworm
2021-09-07 23:19:50 +0000 UTCTall is fine I split the model in 3d builder, it's the mask part over the face, hangs out just a little too far. If I shrink it a little it slices fine. But I need to know if 95% is too small, as it's a 2 day print.
Patrick Devine
2020-10-27 05:47:52 +0000 UTCThis is too tall yes you could lay it on the plate as you would wear it and then only shrink the Y axis (jus make sure uniform scale isnt ticked) and you can easily knock 2-5cm from the length without making it look too squished
Geoffro / Hex3D
2020-10-27 03:21:01 +0000 UTCthe face part seems to be just a little too big for the Ender 3 build plate. How much can i shrink the mask before it might be too small? would i have issues printing at 95%?
Patrick Devine
2020-10-27 03:16:37 +0000 UTCWOOHOO!!!!! Thanks Geoff!!! Oddly enough, in the US, they just had a case of Bubonic plague the other day.
Dante Nava
2020-07-26 22:26:13 +0000 UTC
